Within 5 to 10 seconds you should see the Windows EC7 Desktop shown on your monitor. Note that currently the settings are not saved and need to be configured on each boot cycle, this will be addressed shortly On the dev kit this is done by using the following jumper setting for the "Boot Config" headers : 000100000000ġ) Insert a Win EC7 configured SD card ( Flashing EBoot and OS Files to SD Card) into the MitySOM-335x Development carrier boardĢ) Connect the HDMI/DVI cable to a supported display.ģ) Connect a NULL modem serial cable to the J507 DB9 connector and to your computer.Ĥ) Open a HyperTerminal (or TeraTerm) connection to the COM port connected to the device.ĥ) Set the port's settings to a baud of 115200 with no flow control, no parity and 8 bits.ħ) In the Console window, press space when it asks to break into the bootloader menu (5 seconds).Ĩ) Press to enter the boot device menu.ġ1) Press and disable KITL if it isn't already.ġ2) Press and enable OAL messages if they aren't already. Make sure the Dev Kit (or other carrier board) is set to boot from the SD card.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |